BitX 17a – IF Filter #2
Following up on BitX 17a – IF Filter, @n8dmt suggested that I could use a […]
W1CDN
Ham Radio Adventures
Latest posts
BitX 17a – IF Filter
I was graciously given a partially completed BitX 17a kit by Thaire W2APF back in […]
flrig control via rigctl
I use flrig to control the IC-7300, which means that I can use the GUI […]
HF packet radio on M2 macOS with Xiegu X6100, direwolf, hamlib, and paracon (quick notes)
Install Stuff Configure Stuff Get Going
P3ST Motherboard Photos
I will hopefully add more later about this project. See https://mostlydiyrf.com/p3st/. Note that the linked […]
flrig scripts to switch between radio modes in Windows 10
If you do enough different things with ham radio on Windows, eventually you'll run into a conflict between programs that can talk to your radio via something like flrig--and those that want the whole COM port to themselves. Here are some example scripts that switch between 1) a packet radio environment (that uses UZ7HO SoundModem and BPQ32) using direct COM port access, and 2) a "regular"…
Brown Box Powered Speaker
I had a cheap audio amplifier from AliExpress, a few speakers pulled out of an […]
70 cm Moxon Antenna
Quick post to show this off. I needed a 70 cm antenna for packet radio […]
Homebrew Power Meter – Planning
Because I spend too much time polishing, these are my raw notes for now. If […]
Simple SK/paddle switching on the IC-7300 with flrig
Mostly just copying this info over from my Mastodon account. I originally posted this: “Is […]