My MeshCore Repeater Settings

These are the settings I use in my MeshCore repeater. My repeater lives (like me) in Amsterdam, The Netherlands, so there may be some settings that are region-speciifc. Always check your local MeshCore nerds for specifics in your region.

• MeshCore CLI Documentation
• OTAFIX bootloader for nRF52

Radio Parameters

set radio 869.6179809,62.5,7,5
set radio.rxgain on
set agc.reset.interval 500
set dutycycle 10

GPS/Clock

gps on
gps advert prefs
gps sync

RX/TX delays

set rxdelay 0.5
set txdelay 0.5
set direct.txdelay 0.4

Adverts

set flood.advert.interval 50
set advert.interval 240

Region Codes (Amsterdam / NL / Benelux / Europe)

region put eu
region put nl
region put bx
region put nl-nh nl
region put nl-ams nl
region allowf eu
region allowf nl
region allowf bx
region allowf nl-nh
region allowf nl-ams
region denyf *
region home nl-nh
region default nl-nh
region save

2-byte Path Hash

set path.hash.mode 1

Loop Detection

set loop.detect minimal

Available options: off, minimal, moderate, strict. The default is off. Setting it to minimal is the recommended starting point for all Dutch Meshcore operators.