Common Interface Boards
When I was working for ChargePoint, I designed a set of CIBs (CIB Common Interface Board) for allowing rapid [ ] The post Common Interface Boards appeared first on PhilipMcGaw.com .
PhilipMcGaw.com
Electronics Engineer EMC Embedded Systems Test Automation
Latest posts
Potential Divider Calculator
This calculator performs calculations for potential divider circuits, as well as giving you information about the power and current that [ ] The post Potential Divider Calculator appeared first on PhilipMcGaw.com .
Pressure Material Choices
Since my IPCC Track Width Calculator, I have been thinking about how to make an online alternative to Under Pressure. [ ] The post Pressure Material Choices appeared first on PhilipMcGaw.com .
IPCC Track Width Calculator
Following on from my two IPC 2221 posts, IPC 2221 standard trace widths and the one where I normalised them [ ] The post IPCC Track Width Calculator appeared first on PhilipMcGaw.com .
Programming an ATtiny 1614 using UPDI
The ATtiny 1614 is an 8-Bit microcontroller available in a SOIC-16 form factor. It has 13 available GPIO pins (Not [ ] The post Programming an ATtiny 1614 using UPDI appeared first on PhilipMcGaw.com .
Build a UPDI programmer from a USB to UART adaptor
To build a Unified Program and Debug Interface (UPDI) programmer, I started with a USB-2TTL USB to TTL Serial Communication [ ] The post Build a UPDI programmer from a USB to UART adaptor appeared first on PhilipMcGaw.com .
KiCad Traces Net classes
I have done the following work on Net classes in KiCad, which is derived from what I wrote about IPC [ ] The post KiCad Traces Net classes appeared first on PhilipMcGaw.com .
UART TX/RX Swapping made simple
When designing boards, one of the things I spend a lot of time checking is if my UART transmit (TX) [ ] The post UART TX/RX Swapping made simple appeared first on PhilipMcGaw.com .
Additional Addressing of Nodes
This looks like a way to allow for addressing nodes on a CAN, RS485 or DMX network without needing to use either DIP switches or PCB changes. The post Additional Addressing of Nodes appeared first on PhilipMcGaw.com .
CE mark + CE certificate ≠ CE certification? – Why you can’t just put boxes together
Over on Reddit, there is a post called Client complaining about our own branding on our own custom products, how [ ] The post CE mark + CE certificate ≠ CE certification? Why you can t just put boxes together appeared first on PhilipMcGaw.com .